Brakes are the system where fitment certainty is non-negotiable. A disc with the wrong bore, a pad with the wrong compound or a sensor with the wrong connector is not a near-miss; it is a safety failure. This page covers the brake and safety parts we source, the materials we specify, and how we confirm the part fits before it leaves. As with every category, we quote against an OE number, VIN or model year.
We supply brake pads, discs, brake fluid, hoses, caliper components and wheel-speed sensors for Chinese-brand vehicles plus universal applications. Friction is built to OE specification, with multi-model coverage and E-mark or DOT options where the destination requires them. Fitment is confirmed by OE number or VIN with bore-diameter and interface checks before shipment.
The core range is brake pads and discs, brake fluid, hoses and lines, caliper components and wheel-speed sensors. Pads and discs are the high-frequency items, and we carry OE-spec friction grades matched to the original braking performance rather than a generic substitute. For markets with heat and grade demands, such as Andean highlands or tropical humidity, we specify heat-resistant compounds and higher corrosion protection on the disc hat and edge.
Wheel-speed sensors and related electrical interfaces are matched by connector type and signal, because a sensor that fits mechanically but speaks the wrong protocol will still trigger a warning light. We verify the connector pins and the mounting before quoting.
Disc choice hinges on bore diameter, venting, thickness and the parking-brake interface, all of which can differ between model years of the same vehicle. Pad choice hinges on the friction formulation and the backing-plate detail. We keep these as confirmed attributes, not catalogue assumptions, because the same model name can hide a 2 mm bore difference that changes the whole fit.
Where the destination requires it, brake parts can be supplied with E-mark or DOT options, prepared per order. We do not assume the mark; we confirm the requirement with the destination and the part before arranging the document.
Brake discs are the classic case where model year changes the part. Facelifts and engine variants move the bore diameter, the mounting pattern or the parking-brake drum, so the VIN or original part number is the only safe basis. We read the part number from the original disc or trace it from the VIN, check supersession, and verify the bore and interface.
For mixed fleets we group the order by confirmed variant so each vehicle gets the exact item. This is slower to set up but it removes the returns and, more importantly, the safety risk of a mismatched brake component.
Hot, dusty and mountainous markets wear brakes harder and demand heat resistance and corrosion protection. Coastal and winter-salt markets demand sealed components and anti-corrosion coating. We factor the operating climate into the specification and can split a single shipment into climate-matched variants for different parts of your market.
Brake parts are also among the high-risk categories under several certification regimes, such as EAC in the EAEU, so we plan the documentation alongside the part rather than after the fact.
Yes. Pads, discs, fluid, hoses, caliper parts and wheel-speed sensors can be quoted as one brake kit or as individual lines, all confirmed by OE number or VIN.
Yes, between model years and engine variants the bore diameter and mounting can differ by around 2 mm or more. We verify the exact bore and interface before quoting.
Where the destination requires them, brake parts can be supplied with E-mark or DOT options prepared per order. We confirm the requirement before arranging the document.
A wheel-speed sensor that fits mechanically but has the wrong connector or signal will still set a warning light. We match connector pins and protocol, not just the shape.
Tell us the operating climate. For heat, dust and grade we specify heat-resistant friction and higher corrosion protection on the disc surfaces and hat.
In several markets brakes are high-risk categories, for example under EAC in the EAEU. We prepare the required documents per order and confirm them in writing before shipment.
Send the brake part number or VIN and we will confirm bore, compound and documents.
WhatsApp